Mitel 5340e User's Guide download pdf (Page 66)

5330e/5340e IP Phones – User Guide

Tag Call

Tag Call allows you to signal that you are the victim of a threatening or malicious call. Using

the tag, your system administrator or Telephone Company can identify the source of the call

and provide this information to appropriate personnel or authorities.

CAUTION: Tagging a non-malicious call may result in fines or other penalties.

To tag a malicious call:

1. Press the programmed Tag Call key while the call is in progress. For information on how

to program keys, see Programming Features On Your Keys

-OR-

Press

(TRANS/CONF).

2. Dial the appropriate feature access code.

If the call was successfully tagged, Thank You is shown on the display; otherwise, Not

Allowed is displayed.

Note: Tag Call can be used on active two-party calls only. Calls on hold and conference

calls cannot be tagged.

Trunk Flash

The Trunk Flash feature allows you to access Centrex features (if available) while you are

talking on an outside call.

To flash a trunk while talking on an outside call:

1. Press the key you have programmed to Flash.

Note: You can program a key to single flash or double flash.

2. Wait for dial tone.

3. Dial the Centrex feature access code.

- 58 -

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 96 97

No comments

Mitel 5340e User's Guide Page 66