Mitel 3300 Troubleshooting Guide download pdf (Page 224)

100

101

214

3300 ICP Technician’s Handbook

15. To copy data onto the second new hard drive, complete steps 11 to 13

of the “Replace One Hard Drive in an MXe II/MXe Server” procedure

on page 210.

16. To reinstall and/or relicense the software, follow the steps in "Recover

MXe Server" on page 146.

MXe III (Single Hard Disk or Solid State Drive)

The MXe III ships from the factory without a storage media. Use the

following procedure to install or replace one of the following:

• 160 GB SATA hard drive

• 32 GB SATA solid state drive (SSD)

The flash drive includes MCD software and installs exactly the same way

as a single hard drive

To replace the single hard drive or SSD in an MXe III controller:

1. For first-time installation skip to Step 2. To replace the drive,

- If possible, back up your database (or locate the most recent

backup).

- loosen the captive screw and slide the defective hard (HD1) drive

from the drive carrier.

- remove the four screws that secure the drive to the carrier.

• Slide the (replacement) hard drive or SSD into the drive carrier and

secure with the four screws. Ensure the hard drive is oriented as

illustrated in Figure 75.

Figure 75: Hard Drive / SSD Installed in Drive Carrier

2. Push to seat the hard drive or SSD into the backplane.

Note: To install two hard drives for RAID functionality, see “MXe III (Two

Hard Drives)” on page 215. RAID is not available for solid state drives.

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 431 432

Comments to this Manuals

No comments

Mitel 3300 Troubleshooting Guide Page 224

Comments to this Manuals