Mitel 5606 User's Guide download pdf (Page 40)

5606 Wireless Handset User Guide

a Soft key” on page 28.The Soft/Hot key then enables/disables the alarm. Pressing the Soft

key, or pressing and holding the Hot key toggles the alarm. The “Man-down alarm” icon displays

to indicate that the No-movement alarm is enabled.

Send man-down alarm

The Man-down alarm goes off when the handset is tilted more than 45 degrees for a preset

time (the default is 30 seconds), for example if you fall. Before the alarm is activated, a warning

signal sounds and the “Man-down alarm on” icon flashes. If you do not cancel the alarm by

pressing a key (or the headset button if parameter is set),the alarm is sent and the

“No-movement/ Man-down Alarm” is shown in the display.

Activate the man-down alarm again

After a no-movement alarm has been sent, alarm function can be reset by moving the handset

to upright position or pressing a key.

Acoustic Localisation Signal

A parameter in the handset determines whether an Acoustic Localisation Signal (ALS) should

sound after a no-movement and man-down alarm. The ALS is silenced by pressing the Mute

button.

Delay Time before Warning for No-movement and Man-down Alarms

Your administrator can set the time before the warning for no-movement and man-down alarms

to be delayed for ten minutes, that is, no-movement and man-down conditions will not be

detected during that time. When the time runs out, the warning signal sounds. Press the Mute

button to delay the time to next warning for another ten minutes.

Alarm with Data

Additional data can be sent along with an alarm, for example, a location code.. The data must

be manually defined and stored by the user. To use the function, one Soft/Hot key in the handset

must be defined as a shortcut to the menu “Edit alarm data”, see “Edit a Soft key” on page 28.

The stored data is then added to all types of alarm at transmission. This is a system-dependent

function.

Note: Even if the handset is locked (Phone Lock or Key pad lock), you can press a key

to reset the warning signal.

Note: The alarm button can not be used to reset the warning signal.

Note: If the vibrator function is enabled and the Man-Down alarm is triggered, the alarm

signal is interrupted to sample the movement sensor. To avoid interrupting the alarm

signal, set the ringing period in the ICP to the minimum acceptable time, and the alarm

warning timer to a maximum acceptable time. See your administrator.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 48 49

No comments

Mitel 5606 User's Guide Page 40