Mitel 5606 User's Guide download pdf (Page 45)

Maintenance

Charge the Battery

When the battery icon in the display is empty ( ), the battery requires charging.

Place the handset in the charger. A beep indicates connection with the charger. Charging status

is displayed by the battery icon in the handset display. After approximately two hours for Desktop

Chargers or four hours for Charging Racks, the handset is fully charged, indicated by a filled

battery icon ( ).

If the handset gets switched off automatically due to low battery, and is then placed in a charger,

it remains switched off when fully charged. To start the handset press and hold the ON button.

If the handset is active when placed in the charger, it remains active when fully charged.

Charging Spare Batteries

Spare batteries can be charged in the wall-mounted Charging Rack equipped with the battery

pack adapter.

Figure 5: Inserting a battery in the Charging Rack equipped with an adapter.

Place the battery in the charging slot as shown above. The green LED on the adapter flashes

slowly (every two seconds) while charging and glows steady when the battery is fully charged.

Note: Charging below 0

C (32°F) will harm the battery and shorten the lifetime.

Figure 3.

022

LED

1 2 ... 40 41 42 43 44 45 46 47 48 49

No comments

Mitel 5606 User's Guide Page 45