Mitel 5320e Specifications Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 131
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Mitel IP Phone Reference Guide
Using Phones 23
Register the Handsets with the IP DECT Stand
To register a handset with the IP DECT Stand (gateway), place the handset in the
charging cradle. The first handset automatically registers with the IP DECT Stand after
approximately 30 seconds. To register each additional handset on the same IP DECT
Stand, you must first reboot the stand by pressing RESET on the rear panel of the
stand. While the stand is resetting, Searching for Gateway appears in the handset
display. Note that you cannot register a handset while a call is being supported on
another handset because you will be unable to reset the stand. Power-cycling the stand
will not enable the stand to accept handset registration due to security.
If you have multiple IP DECT stands in close proximity of one another (within 50 meters
indoors, or within 300 meters outdoors), you must manually program the handset IPEIs
into the IP DECT Stand using the VoIP Phone Configurator Web Interface. When you
manually program the IPEI, you ensure that the handsets register with the desired stand.
Assign an IP Address to the IP DECT Stand
The IP DECT Stand requires an IP address on the LAN. Either your LAN must be
configured with a DHCP server that automatically assigns an IP address to the stand, or
you must manually configure the stand with a static IP address and subnet mask.
To manually configure the stand with a static IP address and subnet mask, follow these
steps:
1. From idle mode, press the OK key, select Settings, and then press OK.
2. Select Network settings and press OK.
3. When prompted for a PIN, enter the PIN (Default 0000), and then press OK.
When the IP address menu item is shown in red, then the stand is configured to
obtain an IP address dynamically from a DHCP server.
4. Select IP Mode and press OK.
5. Select Static and press OK.
6. Press Back, select IP address, and then pressOK.
7. Press Erase to delete the current entry (0.0.0.0).
8. Enter a static IP address for the stand. To enter periods in the address, press
Options and then press Insert symbols.
9. Press OK.
Save? appears in the display.
10. Press Yes.
11. Select Subnet mask and pressOK.
12. Enter a Subnet mask.
13. Press OK.
Save? appears in the display.
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 130 131

Comments to this Manuals

No comments