Mitel 1000 guide Owner's Manual download pdf (Page 80)

Press the Speakerphone Key to finish programming.

To configure unequipped line interfaces

The system assumes that available line interfaces have CO lines

connected to them. If a line interface does not have an CO line

connected ensure correct system operation by unequipping the line

interface in system programming, as follows:

From the Programming Extension, press the PROGRAM Key

Press the Scroll Down Key () until ‘System programming’ is

displayed.

Select ‘System programming’.

Enter the System Programming Password and select ‘Lines’.

Press the Scroll Down Key () until ‘Equipped Lines’ is displayed.

Select ‘Equipped lines’.

Select the lines you wish to equip or unequip. Equipped lines are

denoted by a ♦. Unequipped lines are denoted by a ◊.

Press the Speakerphone Key to finish programming.

To configure disconnected extensions

The system assumes that all available extension interfaces have

Desk Phones connected to them. If an extension interface does not

have a Desk Phone connected, ensure correct system operation by

disconnecting the extension interface in system programming, as

follows

From the Programming extension, press the PROGRAM Key

Press the Scroll Down Key () until ‘System programming’ is

displayed.

Select ‘System programming’.

Enter the System Programming Password and select ‘Extensions’.

Press the Scroll Down Key () until ‘Extension disconnect’ is

displayed.

Select ‘Extension disconnect’.

Select the extensions you wish to connect or disconnect.

Disconnected extensions are denoted by a ♦.

Press the Speakerphone Key to finish programming.

Note

When a Desk Phone is connected to an extension interface that is

programmed as disconnected, the Desk Phone display may

appear as if the Desk Phone is connected. However, when the

handset is lifted a busy tone is heard and no options will be

displayed.

To examine system passwords

From the Programming Extension, press the PROGRAM Key

Press the Scroll Down Key () until ‘System programming’ is

displayed.

Select ‘System programming’.

Enter the System Programming Password and select ‘Extensions’.

Press the Scroll Down Key () until ‘Examine passwords’ is

displayed.

Select ‘Examine passwords’.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 86 87 88

Comments to this Manuals

No comments

Mitel 1000 guide Owner's Manual Page 80

Comments to this Manuals

Related products and manuals for Telephones Mitel 1000 guide