Mitel 50005070 Instruction Manual download pdf (Page 164)

100

101

154

SX-200 ICP MX Technician’s Handbook

7. Form 19, Call Rerouting

- Program “Station Dial 0" routing.

The “Station Dial 0" answer point for all tenants must be a Console

LDN or Subattendant LDN. To allow the customer’s PMS to set

message waiting, you must program Day, Night 1, and Night 2 answer

points to the same LDN.

- If you require different “Dial 0" answer points for Day, N1, and N2

use “Priority Dial 0" as an alternate method.

8. Form 34, Directed I/O: program the PMS.

9. Do one of the following:

- Start a Telnet session on the PMS computer to the IP address of the

SX-200 ICP and the socket port number programmed in Form 12.

- Connect the PMS computer to the Layer 2 switch using the

RS232-to-IP serial port converter. Then, program the converter

with the settings in Table 24 on page 149.

10. Verify that the customer’s PMS computer communicates with the

SX-200 ICP.

For serially-connected PMS computers, you will see an exchange of

ENQ (Enquire) and ACK (Acknowledge) commands at the customer’s

PMS computer if it is communicating with the SX-200 ICP. If they are

not communicating, see page 271 for troubleshooting information.

[ Tenant ___ ] Type Of Call Day N1 N2

Station Dial 0 Routing Same LDN Same LDN Same LDN

EXT NUM PRINTOUT PRINTOUT TYPE GUARANTEED

From Form 12 PMS AUTOPRINT NO

Note: For Remote Port, enter the port number programmed in Form 12, not

6830 as the table shows.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 415 416

Comments to this Manuals

No comments

Mitel 50005070 Instruction Manual Page 164

Comments to this Manuals