Mitel 50005070 Instruction Manual download pdf (Page 67)

100

101

Basic Installation

Cabinet installation and programming

The following procedure applies to the installation of new peripheral

cabinets. Cabinets migrating from an existing SX-200 EL/ML installation

install in a different manner; see “Migrating an SX-200 EL/ML to an

SX-200 ICP” in the SX-200 ICP Technical Documentation for more

information

1. Install the peripheral cabinet (including Bay Power Supply, Bay Control

Card, interface cards and required Fiber or Copper Interface Module).

2. Complete the peripheral interface cabling.

See Tip and Ring Assignment tables in Appendix C (page 369) for

cabling and cross connecting the peripheral cabinets.

3. Connect one end of the fiber or copper cable to the interface module

in the control cabinet and the other end to the CIM or FIM connector in

the controller.

4. Power up the cabinet.

5. Enter CDE mode on the maintenance terminal.

6. In Form 04 (System Options/System Timers)

- Enable the required number of TDM Bays (Option 133)

- Make sure there are enough TDM devices available (Options 103).

7. In Form 53 (Bay Location Assignment)

- Assign a bay number to the CIM or FIM ports used to connect the

peripheral cabinets.

8. In Form 01 (System Configuration)

- Configure the cards (select node type as required).

9. Complete the remaining CDE programming for the cards.

For detailed programming information, refer to the SX-200 ICP Technical

Documentation.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 415 416

Comments to this Manuals

No comments

Mitel 50005070 Instruction Manual Page 67

Comments to this Manuals