Mitel 50005070 Instruction Manual download pdf (Page 295)

285

Advanced Troubleshooting and Repair

Assigning Static IP Addresses to IP Phones

To navigate through the set prompts:

• Use the Volume Down key to move to the next field.

• Use the Volume Up key to go back to the previous field.

• Use the * key to move backwards within a field (to correct an error).

• Use the # key to insert a decimal character and move to the next IP

address field.

To set static IP address on the IP telephones:

1. Ensure that the set you want to program is not connected to the

network and there is no power supplied to the set.

2. Hold down the Volume Up key for 3 seconds and at the same time,

plug the set Ethernet cable and power into the set to display the

STATIC IP SETUP MODE.

The SET STATIC IP PARAM? prompt appears.

3. To begin entering static IP address information, press #.

Wait a few seconds for the USE PRESENT SETTINGS prompt to

appear.

4. Press # to enter IP data. To revert back to DHCP from static

parameters, press *.

The INPUT VLAN ID prompt appears.

5. If you are using VLANS, enter the VLAN ID that will be inserted into

packets sent by the phone. Then press the Volume Down key to move

to the next field. If you are not using VLANS, enter nothing and press

the Volume Down key.

The INPUT PRIORITY prompt appears.

6. Enter 6 if you are using priorities, or leave the field blank. Press the

Volume Down key to move to the next field.

The INPUT IP ADDRESS prompt appears.

7. Enter the customer-supplied static IP address (for example:

10.30.27.191).

The INPUT PDA ADDRESS prompt appears.

Note: Enter two-digit portions of IP addresses as three-digit numbers with

leading zeros. For example, enter '10.12.67.30' as '010.012.067.030.

Note: If you see the INVALID IP ADDRESS message, press the Volume Up

key to return to the field with the incorrect entry. Edit the entry.

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 415 416

No comments

Mitel 50005070 Instruction Manual Page 295