Mitel 50005070 Instruction Manual download pdf (Page 85)

100

101

Basic Installation

Door Phone/Door Opener

Customer-provided door phone units (up to four) can be connected to ONS

circuits to provide two-way communication between an entryway and

designated extensions. Door entry is controlled by the general-use relays

in the controller—three at the front panel DB-9 connector and one at the

rear panel RJ-45 connector. Each relay connects to an electric lock that is

operated by key presses at the designated extension(s). See Appendix C

for connector pinouts and relay states.

The relay contacts are rated at 90mA @60 Vac or Vdc peak and are

normally open.

CDE Programming

1. In Form 18, assign an extension number to a Door Relay.

2. In Form 09, enter the Door Relay extension number from Form 18 into

the ASSOC field of the ONS door phone. Assign the door phone a

Name (e.g., Door Phone) to identify it on the door answerer’s display.

3. In Form 19, assign the door phone to its own tenant group and

program Station Dial 0 Routing to direct calls from the door phone to

an answering position.

4. (Optional) Program an Open Door feature key to the door answering

phones.

5. Set COS Option 115 in the door phone’s COS to ring the door

answerer the required length of time (default - 30 seconds).

Note: If you have a Subattendant phone or a console, you can set call

forwarding on the Door Phone to ring a destination instead of programming

it as described above.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 415 416

Comments to this Manuals

No comments

Mitel 50005070 Instruction Manual Page 85

Comments to this Manuals