Mitel 50005070 Instruction Manual download pdf (Page 218)

208

SX-200 ICP MX Technician’s Handbook

Migrating an SX-200 EL/ML to an SX-200 ICP MX

Except for the parts in the table below, most of the EL/ML system,

including the customer database, is preserved in the migration to the

SX-200 ICP MX.

Table 33: Retained and Surplus Parts

Retained Parts Surplus or Unsupported Parts

main cabinet (becomes a peripheral bay) control card in main cabinet

peripheral cabinets SPINE Bays

customer database IP Nodes

peripheral interface cards and modules Control Dual and Triple FIMs/CIMs

telephones and other peripherals ISDN Gateways

COV cards/COV Vmail

SUPERSET 3 and 4 telephones

Datasets for PMS and ACD monitors

Notes:

1. This migration procedure will work only for an MX controller and

not for a CXi controller.

2. An SX-200 LIGHT system must upgrade to an SX-200 EL/ML

(LW, 19.3.2 or later) before migrating to an SX-200 ICP MX.

3. Mitel Express Messenger (MEM) data (programming, greetings

and messages) are not included in the migration. If MEM is

retained, MWI will not be lost. If you continue to use the MEM

card, the database will remain operational provided that you

enable System Option 98 (Support 3DN, 4DN and 400 series Set

Types).

4. Call logs and callback requests are lost in the migration.

5. The IP bay (i.e., the controller) is bay number 1 by default. It

becomes bay number 8 following the migration. All references in

documentation are to the default.

6. The SX-200 ICP supports a maximum of 30 IP trunks. If Option 115

(Maximum IP Trunks) in Form 04 is programmed with more than the

maximum, only the first available 30 IP trunks will function.

7. Migration causes phantom bays on the SX-200 EL/ML to become

peripheral bays on the SX-200 ICP. You must manually re-program

these bays as phantoms in Form 53.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 415 416

No comments

Mitel 50005070 Instruction Manual Page 218