Mitel 50005070 Instruction Manual download pdf (Page 188)

100

101

178

SX-200 ICP MX Technician’s Handbook

Programming the controller IP address and DHCP

settings

The IP address of the SX-200 ICP and its DHCP settings are set at the

factory. Use the following procedure if you need to change them.

To change the controller’s IP address and DHCP settings:

1. Establish a serial connection to the Maintenance port on the

SX-200 ICP Controller (see page 84 for instructions).

2. Log in to the CDE application.

3. In Form 47 (IP Networking), Subform 01 (SYSTEM IP)

- Enter values for IP ADDRESS, IP NETMASK, IP GATEWAY, and

other settings as required.

4. Press ENTER.

5. In Subform 02 (DHCP SERVER)

- Enter the required values. See the SX-200 ICP Technical

Documentation for information on values to use.

- To disable the controller’s DHCP server, press the DISABLE

softkey; press ENABLE to re-enable it.

6. Press ENTER.

7. Reset the system (see page 193 for instructions).

Configuring a Windows 2000 DHCP server (prior to

Release 4.0)

You can modify a Windows 2000 DHCP server to support IP Phones. A

DHCP server must be configured to support the IP Phones for each

subnet. The following items must be configured:

• TFTP Server IP address (system IP address of the SX-200 ICP)

• IP address of the RTC card

• Mitel tag “MITEL IP PHONE”

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 415 416

Comments to this Manuals

No comments

Mitel 50005070 Instruction Manual Page 188

Comments to this Manuals