Mitel 50005070 Instruction Manual download pdf (Page 122)

112

SX-200 ICP MX Technician’s Handbook

4. Press Auto Program.

The system prompts for an extension number to assign to the first

auto-programmed extension. The number is incremented by one for

each subsequent extension—for example, 100, 101, 102.

5. Enter a starting extension number.

Conflicts with existing extension numbers result in an error message

and a prompt to press the CONTINUE or ABORT softkey.

Auto-programming will not proceed to the next BAY/SLT/CCT until a

valid extension number has been found for the current position.

After verifying that the unprogrammed sets are physically connected,

the system automatically programs all unprogrammed circuits. The

system displays all of the devices that have been programmed.

If a circuit cannot be programmed because an extension number has

already been assigned to that circuit, a warning is displayed. Press

ABORT to cancel the procedure or press CONTINUE to skip the

device and resume programming the other devices in the range.

Deleting a Device and All Dependent

Resources

The DELETE softkey in Form 09, Desktop Device Assignments, deletes a

device and all of its dependent resources including

• All line keys (including LDN) that are programmed on a deleted set,

standalone BLF, or PKM module

• All line and feature keys that are programmed on associated BLF or

PKM modules

• The associated BLF and PKM modules

• Any other line appearances and BLFs of the deleted station or set.

A warning message appears if any of the above exists. To continue, press

CONFRIM. To abort, press CANCEL.

Note: The maximum length of extension numbers is five. It is recommended

that the length be equal to the “Length of Mailbox Numbers” in Form 49, to

take advantage of automatic mailbox creation.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 415 416

No comments

Mitel 50005070 Instruction Manual Page 122