Mitel 50005070 Instruction Manual download pdf (Page 133)

123

Basic Programming

To program a static IP address on the NSU:

1. Ensure the NSU is disconnected from the SX-200 ICP Controller and

that no power is applied to the NSU. Re-apply power only after

completing CDE and IMAT programming.

2. If you have not already done so, connect a serial cable from a com port

on your PC to the Maintenance port on the NSU.

3. Launch a Hyperterminal session on the PC (38400, 8, N, 1, no flow

control).

4. Apply power to the NSU by connecting the power cord.

Messages are displayed on the PC while the NSU is booting up.

5. When the PC displays “Press any key to stop this autoboot”, press any

key on the PC keyboard. If you do not stop the autoboot on time,

remove the power cord from the NSU and repeat this step

The PC displays “[MC269AA Boot]”

6. Type ‘c’ on the PC keyboard.

The PC displays “boot device”.

7. Press the Enter key until “net on ethernet” is displayed.

8. Enter the IP Address of the NSU and Subnet mask as shown in the

following example:

192.168.1.2:ffffff00 (where ffffff00 is the subnet mask 255.255.255.0)

9. Press the Enter key until the PC displays “gateway inet (g):”

10. Enter the IP Address of the Gateway as shown in the following example:

192.168.1.1

11. Press the Enter key until the PC displays “[MC269AA Boot]”

12. Enter “@” to continue the bootup or power down the NSU.

Connecting a Windows PC to the NSU

Only the direct cable connection is described here. For information on

connecting to the NSU via modem and or LAN, see the IMAT Online Help.

By default, Windows does not support a direct cable connection. You must

add a device driver. Windows takes the information from a Mitel file and

creates the driver called NT Direct Connection.

Note: There are 6 x f's and 2 x 0's,

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 415 416

No comments

Mitel 50005070 Instruction Manual Page 133