Mitel 50005070 Instruction Manual download pdf (Page 139)

100

101

129

Basic Programming

Programming an Embedded PRI Trunk

1. Form 53, Bay Location Assignment

- Assign the Dual T1/E1 Framer module a bay number.

2. Form 1, System Configuration

- Program the node type as ONB T1 NODE. Program the trunk card

as T1 ISDN for the slots specified in the following table.

Module Location Slot

MMC1 2 and/or 4

MMC2 6 and/or 8

3. Form 03, Class of Service (COS)

- Create a separate COS for ISDN trunks.

- Enable the following COS options for the ISDN Trunks:

246 – SMDR- Extended Record

701 –No Dial Tone

702 –SMDR - Overwrite Buffer. (Required if option 806 SMDR-

Record Incoming Calls enabled)

801 –Incoming Trunk Call Rotary

802 –Limited Wait for Dial Tone

811 –ANI/DNIS Trunk

814 –SMDR - Record ANI/DNIS

Note: Reset the system after updating Form 53.

Note: One link of the Dual T1/E1 Framer can be programmed for PRI (T1

ISDN) and the other for T1 (T1 Trunk).

Note: A trunk must be programmed in form 14 or 15 before it the will show

as installed in Form 1.

Note: COS Level 7 in the default database has all COS options required by

ISDN trunks enabled except for Option 246 (SMDR - Extended Record).

Tip: Ensure that COS Option 800 (ANI Applies) is NOT enabled in the class

of service of the ISDN trunks.

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 415 416

Comments to this Manuals

No comments

Mitel 50005070 Instruction Manual Page 139

Comments to this Manuals