Mitel 50005070 Instruction Manual download pdf (Page 215)

205

Routine Maintenance

3. Insert the system software CD-ROM into the PC or access the file online.

4. Run SX200ICP_SETUP.EXE from the CD.

5. Select Local Upgrade [Flash Card] Installation, then click Next.

6. Select languages for voice mail prompts if applicable. The default is

English and is not selectable.

7. Select the CompactFlash Reader/Writer drive.

8. Select Format to format the CompactFlash card, then click Next.

9. Click Finish when prompted.

10. Wait until the computer completes writing to the CompactFlash card

before ejecting it.

11. Remove the CompactFlash card from the Reader/Writer and insert it

into the card slot on the front of the controller.

12. Log into the Maintenance Terminal and begin a Maintenance session.

13. Press

SYSTEM

RE_START

RESET_SYSTEM

The system boots from the CompactFlash card and installs the new

software. Installation is complete when the phones are up and the LED

next to the card slot turns green.

14. When prompted, log into the Maintenance Terminal in CDE mode and

program all the purchased options from the MOSS sheet. (This step is

not usually required for a software upgrade.)

15. Remove the CompactFlash card from the controller when the LED

adjacent to the card slot turns green.

Note: When formatting the CompactFlash card, select FAT as the file system.

Notes:

• To avoid ending the writing operation before it finishes, DO NOT

click STOP prior to EJECT.

• Certain PC CompactFlash readers have problems with cards

larger than 128M. They report that copying is complete when in

fact not all the files have been copied. If in doubt, eject the card,

re-insert it, and then use Windows Explorer to confirm that files

are present.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 415 416

No comments

Mitel 50005070 Instruction Manual Page 215