43
Basic Installation
Installing the Optional Quad CIM Module(s)
The optional Quad CIM module has four ports that provide connectivity to
Peripheral Cabinets, NSUs, and ASUs using Category 5 UTP copper cabling.
The system can support up to two Quad CIM Modules installed in Module
slots 1 and 2.
To install a Quad CIM Module:
1. Unplug the power cord from the controller.
2. Remove the top cover and the front panel (see page 37).
3. Insert the Quad CIM into Module slot 1 or 2 on the Main Board
connector.
4. Attach the screws.
5. Replace the front panel and the top cover.
Comments to this Manuals